Tooling for powder compacting
46 results for 'Tooling for powder compacting'
Handle, Matrix 220
3R-692.7-220
Handle to circumvent pallet for easier lift off chuck. Comes by different sizes.
Lifting device, Matrix 110 and Matrix 142
3R-692.8-142
In combination with 3R-692.7-110 and 3R-692.7-142 to enable lift by crane.
Punch alignment system
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
Handle, Matrix 142
3R-692.7-142
Handle to circumvent pallet for easier lift off chuck. Comes by different sizes.
Handle, Matrix 110
3R-692.7-110
Handle to circumvent pallet for easier lift off chuck. Comes by different sizes.
Punch unit for Z-distance, Macro
D-20198-ZXX
Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.
Lifting device, Matrix 185 and Matrix 220
3R-692.8-220
In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.
Alignment tool & control Z-distance, Macro PM
90909
Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.
Die unit for Z-distance
D-20198-DZxx
Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.